Hi All,
I am using MDT to capture an image of a computer for later deployment using WDS (towards this end I have utilized these excellent instructions).
From my fully configured client computer (the one that I am about to capture) I issue the command -
net use * \\Server\DeploymentShare$
I then logon with Administrator credentials and am presented with a drive letter (Z in my instances).
I then navigate to Z:\scripts\litetouch.vbs to commence the capture process.
All proceeds fine through MDT/WDS in terms of capturing the image.
However when I boot the client computer up again for the first time I see a message to the effect of 'Could not connect all network drives'.
When inspecting drives using Explorer I see that 'Z' drive is still present, as shown below -
Image may be NSFW.
Clik here to view.
I can right click on the drive and select disconnect. However each time that I reboot I see the drive back inside Explorer.
Attempts to permanently remove the drive using net use /delete have been unsuccessful as shown below -
Image may be NSFW.
Clik here to view.
Finally if I look at the available disks in Computer Management there is no sign of 'Z' drive -
Image may be NSFW.
Clik here to view.
Any help in resolving this issue will be greatly appreciated. Once the issue is fixed I will need to capture another image of the client computer, and hopefully this whole situation will not repeat itself!
Kind Regards,
Davo
